The Aeroplane Speaks. Fifth Edition

1. The angle of incidence may be wrong. If it is too great, it will produce more lift than on the other side of the aeroplane; and if too small, it will produce less lift than on the other side--the result being that, in either case, the aeroplane will try to fly one wing down. 2. Distorted Surfaces.--If some part of the surface is distorted, then its camber is spoiled, and the lift will not be the same on both sides of the aeroplane, and that, of course, will cause it to fly one wing down. Longitudinal Instability may be due to the following reasons: 1. The stagger may be wrong. The top surface may have drifted back a little owing to some of the wires, probably the incidence wires, having elongated their loops or having pulled the fittings into the wood. If the top surface is not staggered forward to the correct degree, then consequently the whole of its lift is too far back, and it will then have a tendency to lift up the tail of the machine too much. The aeroplane would then be said to be "nose-heavy." A 1/4-inch area in the stagger will make a very considerable difference to the longitudinal stability. 2. If the angle of incidence of the main surface is not right, it will have a bad effect, especially in the case of an aeroplane with a lifting tail-plane. If the angle is too great, it will produce an excess of lift, and that may lift up the nose of the aeroplane and result in a tendency to fly "tail-down." If the angle is too small, it will produce a decreased lift, and the aeroplane may have a tendency to fly "nose-down."